Wolf Sub-Zero 700TF Guía de uso y cuidado descargar pdf (Pagina 15)

Cleaning

CONDENSER CLEANING

For all integrated models, the condenser is located behind

the kickplate/grille. To clean the condenser area, remove

the screws holding the kickplate/grille in place. The kick-

plate/grille will slide forward easily, giving you access to

the condenser area. Refer to the illustration below. Using a

soft bristle brush, vacuum to remove dust and lint from the

condenser.

IMPORTANT NOTE: To ensure efficient performance of

your integrated unit, your condenser must be cleaned

every three to six months under normal use. If you have

pets in your home, it may be necessary to clean the

condenser area more often.

Integrated Use & Care 15

subzero.com

Before cleaning, shut off power to the unit at the

electronic control panel. When cleaning the

condenser, wear gloves to avoid injury from the

sharp condenser fins.

Failure to clean the condenser could result in

temperature loss or mechanical failure or damage.

Location of condenser.

Vacation Time

or extended vacations, shut off power to the unit by

pressing the UNIT ON/OFF key pad. Empty all contents

and block the door and drawers open slightly. A one-inch

space will let fresh air in to keep the interior dry and fresh.

IMPORTANT NOTE: Moisture accumulates in a unit that

has been shut off as it warms to room temperature, even if

it has only been in service temporarily and later shut off.

Blocking the door and drawers open slightly will allow the

moisture to escape.

For short vacations, remove all perishable items. Shut off

the ice maker by pressing the ICE MAKER key pad and

empty the ice container. It is not necessary to change the

control settings.

If your religious observances require turning off the lights

and ice maker, see Sabbath mode on page 10.

Moisture accumulation can damage interior metal

components.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Sin comentarios

Wolf Sub-Zero 700TF Guía de uso y cuidado Pagina 15