
Site Preparation 9
subzero.com
An anti-tip bracket and hardware is provided with the inte-
grated unit. Placement of the anti-tip bracket is critical to
a stable installation. The anti-tip bracket must be installed
on a solid base.
If you are installing the unit in a space deeper than 24"
(610), be sure to locate the anti-tip bracket so that it
engages the unit properly. It is important that the anti-tip
bracket is placed 24" (610) from the front of the unit
(without panels) to the back of the anti-tip bracket.
IMPORTANT NOTE: In some installations the subflooring
or finished floor may require angling the wood screws
used to fasten the anti-tip bracket to the back wall. Refer
to the illustrations.
WOOD FLOOR APPLICATIONS
Use the six #12 x 2
1
/2" wood screws and the six
1
/4" flat
washers provided. Drill pilot holes
3
/1
6
" (5) diameter
maximum, and be sure that the screws penetrate through
the flooring material and into the wall plate a minimum of
3
/4" (19). Be sure that the screws hold tight. Refer to the
illustration below.
CONCRETE FLOOR APPLICATIONS
Use the two
3
/8" x 3
3
/4" concrete wedge anchors, two
#12 x 2
1
/2" wood screws and two
1
/4" flat washers
provided. Be sure that the anchors and screws hold tight.
Refer to the illustration below.
Anti-Tip Bracket Installation
Make sure there are no electrical wires or plumbing
in the area which the screws could penetrate.
To prevent the unit from tipping forward and provide
a
stable installation, the unit must be secured in place
with the anti-tip brackets shipped with the unit.
Anti-Tip Bracket Placement A
27" (686) Models 13
1
/2" (343)
36" (914) Models 18" (457)
FINISHED FLOORING
UNDERLAYMENT
CONCRETE
FLOOR
WALL PLATE
SUBFLOORING
Wood floors. Concrete floors.
1
1
/2"
min
(
38
)
FINISHED FLOORING
UNDERLAYMENT
CONCRETE
FLOOR
WALL PLATE
SUBFLOORING
Comentarios a estos manuales