
Integrated Installation 16
Door panel installation.
Panel Installation
DOOR PANEL INSTALLATION
Before attaching the door panel to the door, place two
screws in the center of each mounting position, just
enough that the slotted holes on the hinge side door panel
bracket will slide under the heads. These positioning
screws will support the door panel during installation and
adjustment. Refer to the illustration below.
Install the door panel by engaging the tabbed bracket to
the handle side of the door first and then sliding the hinge
side mounting bracket onto the positioning screws on the
hinge side of the door. The panel can be adjusted
1
/4" (6)
up and down and side to side.
Once the door panel is in place and adjusted correctly,
attach the six remaining #10 x
1
/2" screws to the hinge
side mounting bracket and install the magnetic decorative
caps as shown in the illustration below.
As the reveal between cabinets and the unit
decreases, the potential exists for severe finger
pinching if fingers are placed in the opening when
the door is closing.
5
3
/16" (132)
5
5
/16"
(
135)
8
7
/16"
(214)
11
5
/16"
(287)
1
1
/4"
(32)
1
1
/4"
(32)
23
7
/8" (
606)
F
OR 27" UNITS
3
2
7
/8" (835) FOR 36" UNITS
LH DOOR SWING
BACK OF PANEL
RH DOOR SWING
BACK OF PANEL
BACK OF PANEL
BACK OF PANEL
1
7
/16" (37)
PANEL BRACKET POSITIONING
The illustration below shows mounting hardware location
for door and drawer panels. Dimensions are based on a
1
/8" (3) reveal. A reveal of up to
1
/4" (6) is possible, but
panel dimensions need to be adjusted accordingly.
Comentarios a estos manuales