
9
WOLF WARMING DRAWER USE & CARE
CONTROL PANEL BACKLIGHTING
The Wolf warming drawer has three options
for control panel backlighting; backlight off in
S
abbath, backlight on in Sabbath and backlight
off in all modes. The backlight defaults to ON
in normal use and OFF in Sabbath Mode.
T
o Change Control Panel Backlighting:
Warming drawer must be OFF.
Touch and hold
TEMP
UP arrow and
TIMER
UP arrow for 5 seconds. The current back-
light setting will appear in the LCD display.
Use the
TIMER
UP arrow to scroll through
the three backlight options;
backlight off
in Sabbath, backlight on in Sabbath
(50% power), and backlight off in all
modes.
A selection should be made within
30 seconds. The unit will default to the
current backlight setting if a new selection
is not made within this time.
With the desired backlight setting selected,
touch
POWER ON/OFF
to save the setting.
TEMPERATURE DISPLAY
The warming drawer temperature display can
be changed from Fahrenheit (F) to Celsius (C)
o
r vice versa.
T
o Change Temperature Display:
Warming drawer must be OFF.
Touch and hold both the
TEMP
UP and
DOWN arrows for 5 seconds.
After 5 seconds, the unit will beep, the
backlighting will turn on, and either F or C
will appear, depending on the current
display setting.
Touch the
TEMP
UP or DOWN arrow to
select either Fahrenheit (F) or Celsius (C).
With the desired temperature display
selected, touch
POWER ON/OFF
to save
the setting.
BEFORE USING FOR THE FIRST TIME
Remove all literature and packaging
materials from inside the warming drawer.
Clean your warming drawer thoroughly
with hot water and a mild detergent. Rinse
and dry with a soft cloth. This removes
residual oil and grease left on the surface
from the manufacturing process.
Apply a stainless steel polish to protect the
finish and add luster to the exterior of your
warming drawer. Refer to Care Recommen-
dations on
page 12.
Comentarios a estos manuales