Wolf L Series SO30F Especificaciones descargar pdf (Pagina 3)

3

WOLF L SERIES BUILT-IN OVENS

SITE PREPARATION

IMPORTANT NOTE:

A minimum 24" (610) of

usable cabinet depth is required, or the back

p

anel of the cabinet may need to be removed

for proper installation. The electrical box must

be flush with the back panel of the cabinet.

The installation opening must have a flat, level

b

ase platform to support the oven. Single

ovens require a minimum base support of 250

lbs (113 kg) and the double oven requires a

minimum base support of 400 lbs (181 kg).

The Wolf L Series built-in oven is installed by

inserting into cabinetry from the front. The

ovens have a face trim on all four sides and

will overlap stiles and rails. The trim overlaps

1

/8" (3) on the bottom,

3

/1

6

" (5) on the top and

3

/4" (19) on each side.

IMPORTANT NOTE:

Wolf built-in ovens are

designed and agency approved for installation

with Wolf cooktops, microwaves and warming

drawers only. The nominal width of the built-in

oven should match the nominal width of the

cooktop. A built-in oven cannot be installed

below a Wolf rangetop.

INSTALLATION REQUIREMENTS

IMPORTANT NOTE: This installation must

be completed by a qualified technician.

IMPORTANT NOTE:

Save these Installation

I

nstructions for the local inspector’s use.

Please read the entire Installation Instruc-

tions prior to installation.

Installer:

please retain these instructions

for local inspector’s reference, then leave

them with the homeowner.

Homeowner:

please read and keep these

instructions for future reference and be sure

to read the entire Use & Care Information

prior to use.

IMPORTANT NOTE:

This appliance must be

installed in accordance with National Electrical

Codes, as well as all state, municipal and local

codes. The correct voltage, frequency and

amperage must be supplied to the appliance

from a dedicated, grounded circuit which is

protected by a properly sized circuit breaker or

time delay fuse. The proper voltage, frequency,

and amperage ratings are listed on the product

rating plate.

Record the model and serial numbers before

installing the built-in oven. Both numbers are

listed on the rating plate, located on the right

side of the oven trim, directly above the door.

Open the oven door to view the rating plate.

Refer to the illustration below.

RATING PLATE

INFORMATION

Model Number

Serial Number

Rating plate location

Location

of rating

plate

1 2 3 4 5 6 7 8 ... 15 16

Comentarios a estos manuales

Sin comentarios