Wolf Induction s ICBCT30I Manual de usuario descargar pdf (Pagina 11)

11

I N S TA L L AT I O N I N S T R U C T I O N S

M U LT I P L E CO O K TO P I N S TA L L AT I O N

If the framed induction cooktop is to be used

with any combination of additional cooktop

units or modules with a filler strip, the cut-out

width is calculated by adding the correspon-

ding units’ cut-out dimensions plus 32 mm for

each additional unit. Refer to the illustration

below.

IMPORTANT NOTE:

For Model ICBCT15I/S,

the cut-out width should be increased from

340 mm to 356 mm when installed with

multiple units.

IMPORTANT NOTE:

Unframed induction

cooktops are not designed to be installed in

combination with other cooktops.

IMPORTANT NOTE:

When multiple units are

installed side by side, each unit must have its

own separate recommended electrical circuit.

64 mm

min

FRONT OF COUNTERTOP

489 mm

CUT-OUT

DEPTH

743 mm

TWO MODULES WIDTH

1130 mm – THREE MODULES WIDTH OR

1124 mm – 762 mm COOKTOP AND ONE MODULE

1518 mm – FOUR MODULES WIDTH OR

1511 mm – 762 mm COOKTOP AND TWO MODULES OR

1276 mm – 914 mm COOKTOP AND ONE MODULE

356 mm

CUT-OUT

WIDTH

Countertop cut-out dimensions for installation of multiple cooktops

A C C E S S O R I E S

Optional acces-

sories are available

through your

Wolf dealer. To

obtain local dealer

information, visit

our website,

wolfappliance.com.

When two or more modules are installed

together, an integrated module filler strip

(IFILLER/S) is recommended. If a 762 mm

downdraft ventilation system is also installed,

an integrated module support for downdraft

ventilation (ISUPPORT) is also required.

Contact your Wolf dealer for information on

these accessory components.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 87 88

Comentarios a estos manuales

Sin comentarios