Wolf Sub-Zero 648PROG Guía de instalación descargar pdf (Pagina 8)

PRO 48 Installation 8

IMPORTANT NOTE: For either wood or concrete floor

applications, if the wood screws do not hit a wall stud in

any of the upper holes on the anti-tip bracket, use the

provided #8–18 x 1

/4" wood screw, #12 flat washer and

nylon zip-it wall anchor in its place.

IMPORTANT NOTE: In some installations the subflooring

or finished floor may necessitate angling the screws used

to fasten the anti-tip bracket to the back wall.

Anti-Tip Bracket Installation

IMPORTANT NOTE: Placement of the anti-tip bracket is

critical to a stable installation. Failure to properly position

the anti-tip bracket will prevent it from engaging the unit.

The anti-tip bracket must be installed exactly 26" (660)

from the front of the face frame of the unit to the back of

the anti-tip bracket. Also, the centering line on the lower

flange of the anti-tip bracket must be centered in the

rough opening. Make sure the anti-tip bracket is installed

on a solid base. Refer to the illustration below.

To properly secure the anti-tip bracket for a stable installa-

tion, use all anti-tip bracket hardware as instructed for

wood or concrete floors.

To prevent the PRO 48 from tipping forward and

provide a stable installation, the unit must be secured

in place with the anti-tip bracket provided with the unit.

Make sure there are no electrical wires or plumbing in

the area which the screws could penetrate.

Anti-tip bracket.

Anti-Tip Bracket Hardware

1 Anti-tip bracket

12 #12 x 2

/2" PN HD wood screws

/8"x3

/4" Trubolt anchors

12 #12 flat washers

3 #8–18 x 1

/4"ABPHHDscrews

3 Nylon zip-it wall anchors

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Sin comentarios

Wolf Sub-Zero 648PROG Guía de instalación Pagina 8