Wolf Multi-Function Cooktop Manual de usuario Pagina 6

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 63
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 5
7
INSTALLATION I N S T R U C T I O N S
O V E R H E A D C A B I N E T D I M E N S I O N S
C)
Minimum spacing between overhead side
cabinets must be greater than or equal to
the nominal width of the module(s).
D)
Minimum 457 mm vertical distance from
t
he countertop to the bottom of side
cabinets within minimum side clearance.
E)
Minimum vertical distance between the
countertop and combustible materials
above the cooktop module must be
762 mm.
F)
Minimum 64 mm from rear wall.
G)
Maximum 330 mm depth of overhead and
side cabinets directly above and within side
clearance.
SITE P R E P A R AT I O N
IMPORTANT NOTE:
Installation of the Wolf
gas multi-function cooktop must meet the
following location requirements. All dimen-
sions listed are minimum requirements for
safe operation. Refer to the illustration below.
To eliminate the risk of burns or fire by
reaching over heated surface units,
c
abinet storage space located above the
surface units should be avoided. If
cabinet storage is to be provided, the risk
can be reduced by installing a ventilation
hood that projects horizontally a
minimum of 127 mm beyond the bottom
cabinets.
Failure to locate the cooktop module
without the proper clearances will result
in a fire hazard.
C
G
D
A
B
B
E
F
Minimum installation clearances
L O C AT I O N I N C O U N T E RT O P
A)
Minimum flat countertop surface. Must be
equal to or greater than the width of the
module(s).
B)
Minimum 178 mm wide clearance from the
module side edge to any combustible
surface up to 457 mm above the countertop
(noted by shaded area).
Vista de pagina 5
1 2 3 4 5 6 7 8 9 10 11 ... 62 63

Comentarios a estos manuales

Sin comentarios

Robot Coupe Malé kuchyňské spotřebiče uživatelské příručky

Začínající na R

Klepnutím na abecedu níže přejděte na úplný seznam modelů začínajících tímto písmenem

Modely Typ Dokumentu
R 301 Dice Series
Provozní pokyny   Robot Coupe R 301 Dice Series Operating instructions, 18 stránky
R 301 Ultra
Specifikace   Robot Coupe R 301 Ultra Specifications, 17 stránky
Provozní pokyny     Robot Coupe R 301 Ultra Operating instructions, 34 stránky
Provozní pokyny   Robot Coupe R 301 Ultra Operating instructions, 19 stránky
R 401 Series A
Provozní pokyny   Robot Coupe R 401 Series A Operating instructions, 15 stránky
R 402 Series A
Specifikace   Robot Coupe R 402 Series A Specifications, 22 stránky
Uživatelský manuál   R402 Series A SpecSheet.indd - Kelly, 2 stránky
R 402 V. Series A
Uživatelský manuál   R402 VB Series A - R402 VC [en] , 1 stránky
R100B
Provozní pokyny   Robot Coupe R100B Operating instructions, 13 stránky