Wolf ProScaler Guia de preparacion descargar pdf (Pagina 7)

Wolf Cinema Quick Setup Guide

Connect all sources to the inputs of the scaler.1.

Connect a HDMI cable from the video output on the scaler to input 2(DVI) in the projector.2.

Connect power to the AC input using the provided power cable. The scaler will automatically 3.

turn on. If a Red LED is shown on the right side of the front panel, the Scaler is receiving AC

power but no signal is detected. If a Blue LED is shown, the Scaler is receiving AC power

and a good video signal is being detected. No LED indicates there is no AC power within

the scaler.

All projectors come with 10 Channel Memories that are pre-set for the scalers inputs, the

VariScope lens feature and VariScope 2.35 Anamorphic lens congurations; all based on the

installation specications supplied by the dealer. Once the 10 Channel Memories are calibrated

at the installation, those channel memories can be copied to the remaining empty Channel

Memory slots (11-99).

See the entire Channel Memory chart at end of this Quick Setup Guide.

Channel Memory Setup

Channel 01 HDMI 1 1.78

Channel 02 HDMI 1 1.85

Channel 03 HDMI 1 2.20

Channel 04 HDMI 1 2.35

Channel 05 HDMI 1 2.40

Channel 06 HDMI 1 2.35a

Channel 07 HDMI 1 2.40a

Channel 08 HDMI 1 2.60a

Channel 09 HDMI 1 2.67a

Channel 10 HDMI 1 2.70a

Service

GPIORS-232

AC Input 110-240V, 50/60HzIR Control

Component 2 / RGBHV

Component 1

Video

S-Video

HDMI 1 HDMI 2 HDMI 3 HDMI 4 HDMI 5Video / Audio Audio

Y B-Y R-Y

Sync

Output

Connecting the Scaler

The Projector

Channel Memories

1 2 3 4 5 6 7 8 9 10 11

Sin comentarios

Wolf ProScaler Guia de preparacion Pagina 7