Wolf DCX-1000I Especificaciones descargar pdf (Pagina 84)

3-61

When the projector encounters a system malfunction, either a System Warning message or a

System Error message may appear. Both types of messages are accompanied by a numerical

error code on the status LED display. A system malfunction can be cleared with

Exit

from

presentationlevel,butmayindicatetheneedforservicebyaqualiedservicetechnician.

NOTE: System messages appear on-screen only if Display Error Messages has been set to

“Screen” or “All”.

SYSTEM WARNINGS

A system warning indicates that a system malfunction has been detected (see Status LED Codes,

below). A system warning message replaces any input signal message and disappears when the

input signal status changes. While the projector will remain operational, the message indicates

the presence of a potentially serious problem that should be investigated. You can press

Exit

to remove the message, but for best results you should reset the projector — power the

projector down and up again with the

(power) key.

SYSTEM ERRORS

A system error message indicates that a serious malfunction has been detected and must be

investigated as soon as possible (see Status LED Codes, below). The projector will no longer

operate and must be reset — power the projector down and up again with the

(power)

key.

THE STATUS LED CODES

If the status code display on the back of the projector shows one of the following values, you have

encountered a likely system error requiring the attention of a qualied service technician (see

System Warnings and System Errors, above). Acknowledge and clear the error with

Exit

from presentation level, or try resetting the projector by powering it off and on again, cooling when

necessary. Consult Table 3.6 and contact your dealer if the problem persists.

Thespeciccodenumberidentiesthesourceoftheerrordetected,andisparticularlyusefulin

cases where the projector is far away. For example, the code “27” means the lamp could not be

turned on. Error codes for this projector are listed in Table 3.6 on the next page.

Section3►Operation

System Warnings / Errors

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 150 151

Sin comentarios

Wolf DCX-1000I Especificaciones Pagina 84