Wolf CTEWH45I Guía para resolver problemas descargar pdf (Pagina 9)

9

Dimensions in parentheses are in

millimeters unless otherwise specified.

INSTALLATION INSTRUCTIONS

IMPORTANT

NOTE

You must follow

all National

Electrical Code

regulations. In

addition, be aware

of local codes and

ordinances when

installing your

service.

WIRING

IMPORTANT NOTE:

The ventilation hood

must be properly grounded. It should be

installed by a qualified electrician in accor-

dance with all applicable national and local

electrical codes.

Power connection at hood:

1)

Run supply conductors to the hood wiring

box marked "120 V AC input".

2)

Remove the cover from the wiring box and

remove one knockout as shown in illus 7.

3)

Secure the conduit to the wiring box

through a conduit connector.

4)

Make electrical connections at the hood.

Connect white-to-white, black-to-black and

green-to-ground.

5)

Replace the wiring box cover and screws.

Make sure wires are not pinched between

the cover and box.

Insert the flue extensions setting them on the

hood. Extend the upper flue to the ceiling and

secure with the two screws (H) as shown in

illus 8.

WALL HOODS – DUCTED

FIXING THE TELESCOPIC FLUE

Adjust the width of the support bracket (D) of

the telescopic flue by means of the screws (E)

as shown in illus 5. Then, by means of the

screw anchors and screws (F) provided, fix the

bracket to the ceiling in such a way that it is

positioned along the axis with your hood.

Connect the air outlet pipe to the air vent of

the hood. Use a flexible pipe and lock it to the

air vent of the hood with a metal hose clamp

as shown in illus 6 (pipe and clamp are not

provided).

For exhaust hoods, turn the upper flue over so

that the air exhaust grid is in the lower section.

Illus. 8

Illus. 7

Illus. 5

Illus. 6

3.9 x 6mm

BOX MARKED

120 V AC INPUT

120 VOLT 60Hz

LINE-IN

3.9 x 9.5mm

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comentarios a estos manuales

Sin comentarios