Wolf E SERIES SO30-2U/S Guía de instalación descargar pdf (Pagina 16)

MOUNT OVEN TO CABINETRY

Once the oven is fully inserted into the opening, locate the

mounting holes on the oven side trim. There are four

mounting holes for a single oven and six for a double

oven. Refer to the illustration below. Use a

" drill bit to

drill pilot holes into the cabinet. Using the wood screws

provided, secure the oven to the cabinet.

E Series Oven Installation 16

Install the Oven

POSITION THE OVEN

Carefully lift the oven up to the opening. Resting the oven

on the cabinet base support, slide the oven into the

opening until it is approximately 6"

(152) from full insertion.

Make sure the conduit slides through the opening of the

base support as the oven is moved into place.

IMPORTANT NOTE: The conduit must fit into the recessed

area along the right rear edge of the oven. Make sure it is

not trapped between the oven and cabinet wall.

IMPORTANT NOTE: To avoid interference, a 90° door stop

may be required for any appliance or cabinet door installed

next to an E series oven with tubular handle.

Location of mounting holes.

Failure to install the mounting screws may cause the

oven to tip forward during use.

Do not block the exhaust vent located at the bottom of

the oven. It must remain clear for proper ventilation.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Wolf E SERIES SO30-2U/S Guía de instalación Pagina 16